I was wondering what is the best method of repairing this problem.
Tie leak concrete basement wall.
Water can also seep through the concrete itself seeping into your basement or entering as moisture.
In most cases the front of the tie rod hole will have a inch 6 35 millimeters to 1 2 inch 12 70 millimeters cosmetic covering of concrete.
Gallons upon gallons of water can penetrate through this small void in your basement walls and cause thousands of dollars worth of damage.
Are there any signs that a tie rod has leaked or is going to leak.
After the addition has been able to settle for a period of 1 2 yrs the proper repair to stop water coming through a cold joint would be a urethane injection.
Concrete is a porous material when fully cured.
The appearance of a tie rod leak can vary from a slight discolorization in the wall to the appearance of a leak as seen in this photograph.
Basement walls can leak from multiple locations including through cracks around pipe penetrations in the walls or through basement windows.
I have poured concrete basement walls and several of the tie rod holes are leaking.
Any suggestions would be appreciated.
The trx swell plug is the only product of its kind.
Click for more information crack pipe leaks.
Luckily tie rod hole plugs fill in gaps and reduce leaks in your basement.
Remove the snap tie from the wall wire brush the surface of the concrete.
Because no chemical bond is created when new concrete is poured against old concrete cold joints such as when you put an addition on your home will often leak water.
Higher basement walls may have three rows.
Seal the entire concrete wall with a waterproof masonry.
So far i ve heard of using plain hydraulic cement and also water activated polyurethane.
Homeowners may be surprised by this but 1 leaking tie rod can ruin an entire basement.
How to stop running water coming from a snap tie pocket in a basement wall.
Tie rod holes may also have the surface over the hole missing and appearing as a 5 8 inch diameter hole going through the poured concrete wall.
Typically the rods are removed or broken off after the concrete cured.
These holes are formed from the steel rods that hold the forms of the walls when the concrete is poured.
It can also develop small pinhole openings that act as capillaries for water transmission.