Tools To Cut Laminate Flooring

Two laminate cutters for diy work with a good combination of reasonable cost and good durability are the.

Tools to cut laminate flooring.

Professional models cost 500. Cutting laminate flooring is not an easy task especially if you are not an expert. This tool s portable nature combined with the straight cuts it can perform makes it an excellent choice for laminate flooring. When it comes to cutting laminate flooring most people think that a miter saw and a jigsaw are the best for the task.

Get the vinyl planks under the doorjambs as this provides an even fit of your flooring. So find out the cutting range in width length and also angle when searching for the best tools for laminate flooring. 7 laminate flooring tap bar. Jigsaws are mostly for cutting wood products and laminate flooring is close enough to count as wood.

Exchange a blade 2100005 9 inch laminate flooring cutter. To cut laminate flooring measure and mark the laminate s surface so you know where to cut then use a circular saw or a handsaw with at least 18 teeth per inch to make straight cuts. If you compare a table saw and miter saw the former is best for long straight cuts whereas miter saw works best for angular cuts. A jigsaw is a hand held power tool with a straight narrow blade that moves back and forth.

You can cut and nail the trim to the wall. 12 auger or flat wood drill bits. Different methods to cut the laminate without cracking and chipping are as follows. This is my tool of choice for cutting pieces of laminate to length.

A tablesaw will come in very handy for making rip cuts on laminate flooring and is the fastest and most accurate way to do these types of cuts. 6 non permanent fine tip marker pen. Bullet tools 9 ez shear sharpshooter siding and laminate flooring cutter. 1 tools you need to cut laminate flooring.

The best way to cut the laminate piece is to take the proper measurements and using the right tools attached to the right blades in order to protect it from getting chipped. If you need to make curved cuts create a paper pattern first and place the pattern over the laminate to ensure accuracy when you re cutting. 8 jigsaw special laminate cutting blades. Use a pull bar or a tapping block if the fit is hard to reach.

9 forge profile gauge. Again you might be an expert but you do not have the right cutting tools that will help you complete the task easily and more efficiently.