Tie Rod Clevis Turnbuckle

This creates the only left hand connection to be in the turnbuckle allowing the assembly to be tensioned.

Tie rod clevis turnbuckle.

The second configuration of tie rod assembly consists of two rods with a turnbuckle in the middle and clevises on each end. For this assembly one rod is threaded right hand right hand while the other rod is threaded right hand left hand. Carbon steel turnbuckles are drop forged as per astm f1145. When a turnbuckle dissects the rod assembly both clevises and the end of the rods threading into them will use right hand thread.

Turnbuckles are provided as components of tie rod assemblies that portland bolt manufactures and are often used in conjunction with clevises. Both right hand and left hand threads available upon request to tighten tie rods using turnbuckles or sleeve nuts. By rotating the turnbuckle the tie rod assembly is drawn tight. A clevis is threaded onto each end of the rod and the assembly is drawn tight by turning the rod.

Clevis to clevis turnbuckles not for lifting galvanized steel have a thick coating for mild corrosion resistance. Clevis and turnbuckles come in astm a668 class a f standard to high strength as well as 304 and 316 stainless. Turnbuckles possess right hand internal threads on one end and left hand internal threads on the other. They are right hand threaded one end and left hand threaded the other to allow for easy tensioning of the rods.

As the rod is turned the assembly draws tight. When used with a turnbuckle both clevises will need to be ordered with right hand threads only. 316 stainless steel is the most corrosion resistant and has excellent resistance to chemicals and salt water. They are comprised of clevises rods and a turnbuckle which has a right hand and left hand thread that can be turned in the assembly to increase or decrease tension.

All round bar and hardware are melted and made domestically. Round bar is rolled and threaded to astm specification f1554. Rh clevis tie rod rh lh thread lh clevis tie rods can be adjusted for tensioning due to their right hand and left hand threading this results in easy tensioning. Turnbuckle rods clevis rods hanger rods and sag rods are made to job specifications.

Tie rod and brace rod clevis turnbuckle assembly clevis turnbuckle assemblies are used in bracing and supporting capacities. The most common size turnbuckles in a tie rod assembly are 6 12 takeups. Other sizes are available upon request. 50 foot stock lengths 60 foot available on special request.

Turnbuckles are a standard component used to extend the length of the assembly or increase the adjustability.